For luminous paint spraying
A. For the need for flat paint surface, it is recommended to use the spraying method (air spray gun spray is preferred).
B. When using empty ** spraying, it can be used directly without dilution or add diluent (BAC or toluene) according to the viscosity of the spray, and the amount of diluent should be ≦5% to avoid reducing its hiding power.
C. Luminous paint is a genus (oily self-drying spray paint), which contains polar organic solvents, and may be suspected of erosion of general water-based paint and elastic paint paint, for the sake of caution, please try it in a small area or hidden place before use.
1. Clean the surface of the covered object before spraying, if it is uneven, please repair the surface of the covered object first; And after it is completely dry, it is best to pre-spray the acrylic series white (flat) primer.
2. In order to make the luminous paint have a better light storage effect, it is recommended to spray the acrylic series white (flat) primer as the bottom layer before spraying.
3. After the spraying primer is completely dry, please spray the luminous paint 15-25 cm away from the surface of the covering, and spray a thin layer for about 5-10 minutes before spraying the second one.
4. The time between each spraying should be 5-10 minutes, and at least three spraying should be the minimum benchmark, depending on the uniformity after spraying; A fourth or more can be sprayed, and its light storage capacity is stronger (that is, better brightness at night) as the thickness of the spray film increases.
5. Glow-in-the-dark paint (refers to the drying time of about 15-20 minutes), after spraying, you can spray transparent paint again as needed, so as to make the surface of luminous paint brighter and more durable.
For painting
A. It is recommended to use the brushing method for small areas of the coating (use a special brush for paint).
B. When using the brush, it is not necessary to dilute it, it can be used directly, or the viscosity needs to be added as much as the diluent (BAC or toluene), and the amount of diluent added should be ≦5% to avoid reducing its hiding power.
C. Luminous paint is a genus (oily self-drying spray / brush paint), containing polar organic solvent, the general water-based paint, elastic paint paint may have erosion doubts, for the sake of caution, please try it in a small area or hidden place before use.
1. Clean the surface of the covered object before painting, if it is uneven, please repair the surface of the covered object first and wait for it to dry completely, and then pre-spray the acrylic series white (flat gloss) primer.
2. In order to make the luminous paint have a better light storage effect, it is recommended to spray the acrylic series white (flat) primer as the bottom layer before painting.
3. After the sprayed or brushed primer is completely dry, then apply the luminous paint, when painting the covered object, please complete a thick coating operation in the same direction, wait for 15-20 minutes to wait for its surface to dry slightly, and then carry out the second operation in the same way as above.
4. During the painting construction, the brush should not be painted back and forth by moving up and down or left and right, so as to avoid uneven dispersion of the luminous powder and seriously affect its light storage capacity.
5. The interval between each coating should be 15-20 minutes, it is recommended to apply at least four as the minimum benchmark, depending on the uniformity after painting, a fifth or more can be added, with the thickening of the paint film, its light storage capacity is stronger (that is, the brightness at night is better).
6. Luminous paint (refers to the drying time of about 20-30 minutes), after the completion of painting, you can spray or paint transparent paint again as needed, so that the surface of the luminous paint is brighter and the use time is longer.
Glow-in-the-dark paint construction
Luminous paint can only function after being brushed to form a paint film. Therefore, dry thoroughly.
